Debug Qos-Manager - Cisco Catalyst 3560-X Command Reference Manual

debug qos-manager

debug qos-manager
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
B-84
Downloaded from www.Manualslib.com
Use the debug qos-manager privileged EXEC command to enable debugging of the quality of service
(QoS) manager software. Use the no form of this command to disable debugging.
debug qos-manager {all | event | verbose}
no debug qos-manager {all | event | verbose}
all Display all QoS-manager debug messages.
event Display QoS-manager related-event debug messages.
verbose Display QoS-manager detailed debug messages.
Debugging is disabled.
Privileged EXEC
Release Modification
12.2(53)SE2 This command was introduced.
The undebug qos-manager command is the same as the no debug qos-manager command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command Description
show debugging Displays information about the types of debugging that are enabled.
manuals search engine
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02