Debug Platform Stack-Manager - Cisco Catalyst 3560-X Command Reference Manual

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform stack-manager

Note
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Related Commands
OL-21522-02
Downloaded from www.Manualslib.com
Use the debug platform stack-manager privileged EXEC command to enable debugging of the stack
manager software. Use the no form of this command to disable debugging.
debug platform stack-manager {all | rpc | sdp | sim | ssm | trace}
no debug platform stack-manager {all | rpc | sdp | sim | ssm | trace}
This command is supported only on Catalyst 3750-X switches.
all Display all stack manager debug messages.
rpc Display stack manager remote procedure call (RPC) usage debug messages.
sdp Display the Stack Discovery Protocol (SDP) debug messages.
sim Display the stack information module debug messages.
ssm Display the stack state-machine debug messages.
trace Trace the stack manager entry and exit debug messages.
Debugging is disabled.
Privileged EXEC
Release
12.2(53)SE2
The undebug platform stack-manager command is the same as the no debug platform
stack-manager command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable e
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command
show debugging
manuals search engine
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Catalyst 3750-X and 3560-X Switch Command Reference
debug platform stack-manager
B-73