Preparations And Execution As Of Nc Software 34049X-02 (Dual-Processor Version) - HEIDENHAIN iTNC 530 Service Manual
Hide thumbs
Also See for iTNC 530:
- User manual (745 pages) ,
- Service manual (696 pages) ,
- Technical manual (624 pages)
Table of Contents
Advertisement
27.4 Preparations and Execution as of NC Software 34049x-02 (Dual-Processor Version)
Downloading the
If you have access rights to the protected range of the HEIDENHAIN website (member area),
new service pack
you can download the current service packs.
For this purpose proceed as follows:
In the internet, go to www.heidenhain.de.
Click on Services/Member-Area/FileBase.
Enter your user name and your password.
Click on NC Milling iTNC530.
Click on Software or Software export.
Select the corresponding service pack with the highest version for the NC software on your
machine (e.g., 34049002 - iTNC530 (DP) service pack 2).
Download the service pack onto your laptop/PC or a USB stick.
Decompress the ZIP file (e.g., 34049202sp2.zip) onto the USB stick or into a folder on the
laptop.
A folder with the number of the NC software (e.g., 34049202) is created. It is located in a
subfolder (e.g., 340492_002_SP2) that contains the files setup.exe and setup.zip.
End users may receive the service packs via the machine manufacturer.
Preparing the
Move machine to home position (axed, tool changer, tilting head, etc.).
Ask the machine operator!
machine
Restart the control, do not acknowledge the "Power interrupted" message
Press EMERGENCY STOP.
Access to the
If your control is connected to the company network and the service pack files were filed on a
service pack files
released folder of the network, you have access to these data. --> If necessary, ask the system
administrator.
You may also use a USB stick as data medium, as described in the following ...
Loading the
service pack
Connect the USB stick to X141 or X142 (USB interfaces of the iTNC 530).
Now work with Windows.
With the Windows explorer, e.g., open the folder on the USB stick, that contains the setup
files.
May 2006
Caution
With the dual-processor version of the iTNC 530 as of NC software 34049x-02, service packs
are installed with Windows. You need the corresponding Windows authorizations to install
the software. If necessary, ask the machine manufacturer!
Note
When attached, USB devices that use the VFAT or ISO 9660 file systems (not NTFS or other
systems), are detected and connected automatically.
27 – 449
Advertisement
Table of Contents
Troubleshooting
