HEIDENHAIN iTNC 530 Service Manual page 517

MP
MP7291
MP7291.0
MP7291.1
MP7291.2
MP7294
MP7295
MP7296
MP7300
May 2006
Function and input
Display of axes on the screen
Format:SXYZABCUVWxyzabcuvw-
Input:Characters 1 to 9 from the right
represent lines 1 to 9
Character 10 is spindle S which is always output
in line 10.
Display in traverse range 1
Display in traverse range 2
Display in traverse range 3
Disable axis-specific "Datum setting" in the preset table
Format:%xxxxxxxxxxxxxx
Input:Bits 0 to 13 represent axes 1 to 14
0: Not disabled
1: Disabled
Disable "Datum setting"
Format:%xxxxxxxxxxxxxx
Input:Bits 0 to 13 represent axes 1 to 14
0: Not disabled
1: Disabled
"Datum setting" through axis keys
Input:0: Datum can be set by axis keys
and soft key
1: Datum can be set only by soft key
Erasing the status information, tool data and Q parameters
Input:0: Erase the status information, Q
parameters and tool data when a program is sel-
ected.
1: Erase the status information, Q parameters
and tool data if a program is selected and in the
event of M02, M30, and END PGM.
2: Erase the status information and tool data if a
program is selected.
3: Erase the status information and tool data if a
program is selected and in the event of M02,
M30, END PGM.
4: Erase the status information and Q parame-
ters if a program is selected.
5: Erase the status information and Q parame-
ters if a program is selected and in the event of
M02, M30, END PGM.
6: Erase the status information if a program is
selected and in the event of M02, M30, END
PGM.
7: Erase the status information if a program is
selected and in the event of M02, M30, END
PGM.
Behavior/
SW vers.
PLC
RUN
340 422-01,
340 480-02
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
30 – 517