Connection Setup; Via Ethernet - HEIDENHAIN iTNC 530 Service Manual

16.2 Connection Setup

16.2.1 Via Ethernet

You need:
Connection via your Ask your system administrator, if necessary!
local network
Connection It is advisable to set up a direct connection between your service laptop and the control (peer-
Establishment at to-peer).
the customer's

(field service)


May 2006
A laptopt/PC with Ethernet card
Either a Ethernet crossover cable for the direct connection between laptop and control
(peer-to-peer connection) or a non-crossed Ethernet cable (patch cable) for connection via
your local network (intranet).
Note
Mark your cable as "crossed" or "non-crossed"!
Ask your customer whether you may disconnect the control from his in-house network for the
duration of your work.
Connect your laptop directly to the control by means of a crossed Ethernet cable.
Note
You can read the IP address and the subnet mask of the control after entering the code
number NET123 and pressing the DEFINE NET soft key.
With the dual-processor control, the IP settings of Windows are managed.
The HEIDENHAIN code number NET123 has no effect. You can enter the command
ipconfig in the prompt. Subsequently read the settings in the line Ethernet adapter Local
Area Connection.
Or click on My Computer\Control Panel\Network ...
Contact your system administrator.
Now either adapt the IP address and the subnet mask of your laptop to the IP address and
the subnet mask of the iTNC, or vice versa.
16 – 247