Err Key - HEIDENHAIN iTNC 530 Service Manual

Hide thumbs Also See for iTNC 530:

Table of Contents

ERR Key

If there is an AND symbol (little red roof) in the header in addition to the error message, there is

more than one pending error message.

The ERR key (ERROR) is located directly over the HELP key. If this key is pressed, an error list

appears. All pending NC and PLC error messages of the control are displayed in an own window.

In addition, the help window can be called with the HELP key.

Display all pending error messages

(if this key is pressed again, the window will be closed)

If there is no ERR key over the HELP key on your keyboard, press the corresponding space

bar over the HELP key. --> If the NC software of the iTNC 530 supports the function of the

ERR key, the ERR list can also be called!

HEIDENHAIN Service Manual iTNC 530