Nc Software Exchange From Standard Version To Export Version - HEIDENHAIN iTNC 530 HSCI Technical Manual

Hide thumbs Also See for iTNC 530 HSCI:

Table of Contents

exchange from

standard version to

export version (and

The control version (iTNC 530 or iTNC 530 E) is stored in the SIK. If the NC

software is exchanged on a software version different from that stored on the

SIK, after the control starts up a message appears that the control can be

operated only as a programming station. This message must be

acknowledged.

Procedure for exchanging the NC software:

Exchange the NC software as described above.

After the control powers up, Incorrect software version appears.

Switch off the control.

Exchange the SIK for a new, appropriate SIK (for the ID, see page 82); for

the location of the SIK in the MC 6xxx, see page 209.

Switch on the control.

Since the new SIK has another SIK number, the options that are enabled on

the old SIK must be re-enabled on the new SIK. After you state your SIK

number, HEIDENHAIN can give you the code numbers for enabling the

To make it possible to identify the control from outside, after you indicate the

ID and serial number of the control, you will receive a new ID label with the

Stick the new ID label with the new control designation on the MC 6xxx.

After you have changed the NC software from the standard version to the

export version, you must delete the packed files of the standard version

from the hard disk, since the packed files are also subject to export

authorization.

After the export version has been started, a prompt appears, asking if the

compressed files of the standard version are to be deleted from the hard

disk. If you answer with YES, all compressed files with the names of the

standard version are deleted from the hard disk.

The procedure for deleting compressed files is on page 162.

HEIDENHAIN Technical Manual iTNC 530 HSCI