Checking The Enables On The Itnc; General - HEIDENHAIN iTNC 530 Service Manual

19 Checking the Enables on the iTNC

19.1 General

With an operating axis (axis in control) ...
To operate with axes or spindles the appropriate enables are required.
If one or several enables are missing, an error message is output or the axes and/or the spindles
cannot be operated.
The following conditions must be fulfilled to drive digital axes and spindles:
May 2006
No terminal symbol is shown
The "STIB" star (control in operation) is shown.
The feed rate enable must not be highlighted.
The position display changes in case of a movement.
READY
symbol
Clamping
symbol
Feed rate
display
I3 set
(X42/4, Control-is-ready signal acknowledgement)
I32 set
(X42/33, global drive enabling; the functionality of the I 32 global drive enabling is defined in
MP 2050.
24V at X150 / 151 for the corresponding axis group is available.
(X150/151 are not wired on every machine,
but if they are, you can see in MP 2040, how the axis groups are assigned)
Position display
19 – 311