HEIDENHAIN iTNC 530 Service Manual page 470

Activate the copy of
the original MP file
for test purposes
Edit and mark
machine parame-
ters

Search Machine If you have marked the parameter ...
Parameters



In case the number of the parameter is known ...


In case the number of the parameter is known (but not the number) ...



30 – 470
 Place the cursor on the working copy, e.g., TEST.MP
 Load this file into the Editor

When the key is pressed, the iTNC 530 carries out a reset and activates the sel-
ected MP file. The original MP file is activated in the same way.
Note
In the program management, the active MP file has the entry M in the status column.

Where ist makes sense, set the editing mode to Insert or Overwrite.
Note
For bit-coded parameters the "Overwrite" editing mode is provided, otherwise "Insert" should
be selected. The original values are thus retained.
Mark the modified machine parameters to find them later again.
Enter a semicolon (to mark a comment) after the modified parameter and subsequently an
identification word (e.g., your name, company name, etc.).
 Place the cursor with the arrow key in the next line. --> The modified line is struc-
tured.
Press the SEARCH soft key and enter the marking word.
With the corresponding soft key, select whether capitalization shall be of importance or not.
Press the EXECUTE soft key. --> The editor places the cursor to the marking word.
Press the GOTO key and enter the number (without index).
Confirm with ENTER. --> The editor places the cursor at the requested parameter.
Press the SEARCH soft key and enter the name.
With the corresponding soft key, select whether capitalization shall be of importance or not.
Press the EXECUTE soft key. --> The editor places the cursor on the required text. If the asso-
ciated parameter is not the one you have been looking for, just press SEARCH and EXECUTE
until it is found.
HEIDENHAIN Service Manual iTNC 530