HEIDENHAIN iTNC 530 Service Manual page 507

MP
MP6500
MP6505
MP6505.0
MP6505.1
MP6505.2
MP6507
MP6510
MP6510.0
MP6510.1
May 2006
Function and input
Tool measurement with TT 130
Format:%xxxxxxxxxxxxxxx
Input:Bit 7 – Reserved
Bit 8 – Probing routine
0: Probe contact is probed from several direc-
tions
1: Probe contact is probed from one direction
Bit 9 – Automatic measurement of the direction
of the probe contact basic rotation (bit 8 = 1)
0: Basic rotation is not measured
1: Basic rotation of the probe element is automa-
tically measured
Bit 10 – Probing routine (bit 8 = 1)
0: Pre-positioning to starting point in all three
principal axes
1: Pre-positioning to starting point in the tool axis
and in the axis of the probing direction (MP6505)
(bit 9 = 0)
Bit 11 – Tool checking and changing in
the tool table
0: After Tool checking the tool table is
changed
1: After Tool checking the tool table is
not changed
Bit 12 – PLC datum shift
0: Do not include
1: Include
Bit 13 –
0: Tool is measured in the tilt position in which
the tool touch probe was also calibrated
1: Tool is measured in another tilt position
Bit 14 – Tool measurement with number of
teeth = 0
0: Tool measurement with rotating spindle
1: Tool measurement with stationary spindle
Probing direction for tool radius measurement for 3 traverse
ranges
Input:0: Positive probing direction of the
angle reference axis (0° axis)
1: Positive probing direction in the +90° axis
2: Negative probing direction of the angle refe-
rence axis (0° axis)
3: Negative probing direction in the +90° axis
Traverse range 1
Traverse range 2
Traverse range 3
Calculation of the probing feed rate
Input:0: Calculation of the probing feed
rate with constant tolerance
1: Calculation of the probing feed rate with varia-
ble tolerance
2: Constant probing feed rate
Permissible measuring error for tool measurement with
rotating tool
Input:0.002 to 0.999 [mm]
First measurement error
Second measurement error
Behavior/
SW vers.
PLC
RUN
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
30 – 507