HEIDENHAIN iTNC 530 Service Manual page 437

Adapting the Only necessary if you want to transmit backup files via Ethernet interface and the NC software
MPNAME.MP version of the control is smaller than 340420-08!
If the file MPNAME.MP is now displayed on the screen:

Setting up the 
data interface

Defining the NC 
software version
May 2006
Press END to start the control again (with machine parameter list MPNAME.MP created by
the operating system, the control is set to programming station).
Note
If entries for additional control-loop indexes are now required in the machine parameter list
(error message MP: not defined) or there seem to be too many control-loop indexes (error
message MP: incorrect number), then ...
Delete MPNAME.MP. --> An adapted MPNAME.MP will be generated automatically.
Press END. --> The control boots and generates the Power interrupt message.
Background:
The MP list on the new HDR has a basic configuration of the control-loop indexes. The
number of control loops of the CC used by the customer may deviate from this basic
configuration. It may thus happen that the MPNAME.MP of your CC has too many or
insufficient control-loop indexes. But this is not a problem! By deleting the MPNAME.MP,
the iTNC 530 generates an MPNAME.MP correlates to your CC.
Note
As of NC software version 340420-08, the code number NET 123 for setting up the Ethernet
configuration is also accepted with open MP list.
Either make the settings for the Ethernet transmission on the control.
--> See "Via Ethernet" on page 16 – 247.
Subsequently, protect the IP4.N00 file to make sure it is not overwritten!
Or define the settings for the RS 232 interface.
--> See "Via Serial Interface RS 232/V.24 or RS 422/V.11" on page 16 – 256
Control the active NC software version.
If you need another software version, it must be loaded now. --> Please contact your machine
manufacturer!
26 – 437