Exchange Of Heidenhain Components; Important Information - HEIDENHAIN iTNC 530 Service Manual

26 Exchange of HEIDENHAIN Components

26.1 Important Information

Which items can be
exchanged?
NC software update An NC software update can only be performed by the machine manufacturer or after
consultation with the machine manufacturer, as ...
May 2006
DANGER
Observe the safety precautions to avoid damage to persons or machines.
--> See "Safety Precautions" on page 1 – 9.
Caution
Exchange only original HEIDENHAIN components!
MC
(Main Computer = housing part with computer)
CC
(Controller Computer = housing part with controller)
Drive assembly
(Hard disk with adapter board and holding plate in the MC 422)
HDR
(Hard Disk Removable for the MC 422 B)
SIK
(System Identification Key)
Connected HEIDENHAIN units
(e.g., encoders, inverters, motors, handwheels, probes, etc.)
Cables and accessories
Fan
Buffer battery
An export license is required for the NC software!
The NC software must be released by the machine manufacturer!
It might be necessary to adapt manufacturer cycles.
It might be necessary to rename tables for cutting data, M function macros, tilting-axis
geometry, etc.
It might be necessary to install service packs for the NC software.
Corresponding local user rights are required for dual-processor controls with Windows 2000.
It might be necessary that new functions are activated.
It might be necessary that new machine parameters have to be defined.
The NC software update is different for single-processor and dual-processor controls and has
become relatively complicated (partly due to the above reasons).
Note
The NC software update for the single-processor and dual-processor control is described in
the Technical Manual iTNC 530 which is available to the machine manufacturer!
26 – 411