HEIDENHAIN iTNC 530 Service Manual page 526

MP
MP7500
30 – 526
Function and input
Tilt working plane (inactive preset table)
Format:%xxxxxxxxx
Input:Bit 0 – "Tilted working plane"
0: Off
1: On
Bit 1 –
0: Angles correspond to the position of the tilting
axes of the head/table
1: Angles correspond to the spatial angle (the
iTNC calculates the position of the tilted axes of
the head/table)
Bit 2 –
0: The tilting axes are not positioned with
Cycle19
1: The tilting axes are positioned with Cycle 19
Bit 3 –
0: The current tilting-axis position is taken into
account with respect to the machine datum
1: The 0° position is assumed for the first rotary
axis
Bit 4 –
0: Compensate
exchange of the spindle head when calling
M128, M114, TCPM or "tilted working plane"
1: Compensate mechanical offset during PLC
datum shift
Bit 5 –
0: The current tilting-axis position is taken into
account with respect to the machine datum
1: The tilting-axis position that was entered with
the 3-D ROT soft key applies.
Bit 6 –
0: Spatial angle C is realized through a rotation of
the coordinate system.
1: Spatial angle C is realized through a rotation of
the table
Bit 7 –
0: The current tilting-axis position is taken into
account with respect to the machine datum
1: The active tilting-axis position is
a) derived from the tilting angles in the 3D ROT
window if manual tilting is active
b) derived from the reference coordinates of the
rotary axes if tilting is inactive
Bit 8 –
0: The tilting axis positioning is considered
depending on bit 3, bit 5 and bit 7
1: If manual tilting is active, the datum to be set
for the principal axes X, Y and Z is recalculated
back to the home position of the tilting element
mechanical offset during
HEIDENHAIN Service Manual iTNC 530
Behavior/
SW vers.
PLC
RUN