Description: Sets the VPS "system voltage" calibration.
Command Level: 6
Syntax: SET VORTEX SYSTEM CALVOLT
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA:
Power system did not accept the new value, setting remains
unchanged.
Related Commands: none
Example:
Command<6>: SET V SYSTEM CALVOLT
System calibrate voltage: 50.48 VDC
System calibrate voltage:
Page 3-260
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Spec. Nos. 586505000 and 5865055000 (Model LMS1000)