Set Vortex System Curlimit - Emerson LMS1000 User Instructions

User Instructions
Spec. Nos. 586505000 and 5865055000 (Model LMS1000)

SET VORTEX SYSTEM CURLIMIT

Description: Sets the VPS "current limit value".
Command Level: 6
Syntax: SET VORTEX SYSTEM CURLIMIT
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Power system did not accept the new value, setting remains
unchanged.
Related Commands: none
Example:
Command<6>: SET V SYSTEM CURLIMIT
Current limit: 500 Amps
Current limit:
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SE V SY CURLIMIT
Chapter 3. Commands
Section 5847
Issue AL, July 24, 2006
Page 3-261