Set Vortex System Hvs - Emerson LMS1000 User Instructions

Section 5847
Issue AL, July 24, 2006

SET VORTEX SYSTEM HVS

Description: Sets the VPS "high voltage shutdown" value.
Command Level: 6
Syntax: SET VORTEX SYSTEM HVS
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The MCA does not allow an adjustment which could result in a service
interruption. Refer to the VPS instruction manual's high voltage shutdown adjustment
procedure for details.
The following message is displayed if the setting was not accepted by the MCA.
Power system did not accept the new value, setting remains
unchanged.
Related Commands: none
Example:
Command<6>: SET V SYSTEM HVS
System How Voltage Shutdown: 59.50 VDC
System How Voltage Shutdown:
Page 3-266
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
SE V SY HVS
Chapter 3. Commands
User Instructions