Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
SET VORTEX SUBSYSTEM CALVOLT
Description: Sets the VPS "subsystem voltage" calibration.
Command Level: 6
Syntax: SET VORTEX SUBSYSTEM CALVOLT
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Power system did not accept the new value, setting remains
unchanged.
The following message is displayed if a subsystem is not installed.
No Subsystem Installed
Related Commands: none
Example:
Command<5>: SET V SUBSYSTEM CALVOLT
Subsystem Calibrate Voltage: 27.60 VDC
Subsystem Calibrate Voltage:
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.