Snmp Commands - Emerson LMS1000 User Instructions

Section 5847
Issue AL, July 24, 2006

SNMP Commands

This section provides an alphabetical list of all SNMP commands available when the
SNMP software option is installed, with a short description of each command.
SNMP Commands
SNMP
SNMP GET <comm name>
SNMP OFF
SNMP ON
SNMP SET <comm name>
TRAPS
TRAPS ADD <n>
TRAPS DELETE <n>
TRAPS OCCURRED
TRAPS OFF
TRAPS ON
TRAPS PERSISTENT
TRAPS RETIRED
TRAPS VERSION
Page 3-16
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
display the current value of the SNMP options
set the SNMP GET community name
disable SNMP access
enable SNMP access
set the SNMP SET community name
display the SNMP TRAP information
add a new SNMP Trap recipient to the list of TRAP hosts
remove a host address from the list of TRAP hosts
disable/enable the systems ability to send SNMP Occurred Alarm TRAPS
disable the systems ability to send SNMP TRAPs
enable the system to send SNMP TRAPs
Disable/Enable the systems ability to send SNMP Persistent Alarm TRAPS or
set the Persistent Alarms reporting interval
Disable/Enable the systems ability to send SNMP Retired Alarm TRAPS
change the version of SNMP TRAPs sent by the system
Chapter 3. Commands
Description
User Instructions