Emerson LMS1000 User Instructions page 174

Section 5847
Issue AL, July 24, 2006
SET VORTEX SYSTEM 50APLACES
SET VORTEX SYSTEM 100APLACES
SET VORTEX SYSTEM 200APLACES
SET VORTEX SYSTEM 50%BATONDISCH
SET VORTEX SYSTEM BATONDISCH
SET VORTEX SYSTEM CALVOLT
SET VORTEX SYSTEM CURLIMIT
SET VORTEX SYSTEM FACTORYCAL
SET VORTEX SYSTEM FLTVOLT
SET VORTEX SYSTEM HIVLTALM1
SET VORTEX SYSTEM HIVLTALM2
SET VORTEX SYSTEM HVS
SET VORTEX SYSTEM INVENTORY
SET VORTEX SYSTEM MODE
SET VORTEX SYSTEM NAGTIMER
SET VORTEX SYSTEM OVRCURRENT
SET VORTEX SYSTEM TEMPCOMP
SET VORTEX SYSTEM TSTEQVOLT
SET VORTEX SUBSYSTEM CALVOLT
SET VORTEX SUBSYSTEM FACTORYCAL
SET VORTEX SUBSYSTEM HIVALM
SET VORTEX SUBSYSTEM LVALM
SET VORTEX SUBSYSTEM OVRCURRENT
UPLOAD VORTEX
where: <> anything enclosed in brackets is optional
n is a valid number
t is A or B for Vortex LVD settings
Page 3-92
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
set system number of 50A Places
set system number of 100A Places
set system number of 200A Places
set system 50% Battery On Discharge alarm
set system Battery On Discharge alarm
set system calibration voltage
set system current limit
set system cal. voltage to factory default
set system float voltage
set system High Voltage 1 Alarm
set system High Voltage 2 Alarm
set system High Voltage Shutdown
reset the system equipment inventory
set Power System mode
set system ACO timer
set system Overcurrent alarm
set system Temperature compensation voltage
set system test/equalize voltage
set subsystem calibration voltage
set subsystem cal. voltage to factory default
set subsystem High Voltage alarm
set subsystem Low Voltage alarm
set subsystem Overcurrent alarm
configure Vortex Power System by
uploading file using XMODEM
protocol
Chapter 3. Commands
User Instructions