KEB COMBIVERT F5 Instruction Manual page 93

Parameter Description - Encoder Set Up
This parameter reads or writes data from or to the encoder. It is only
supported by HIPERFACE or EnDAt encoders.
When the encoder is supplied pre installed from the motor manufacturer,
the motor manufacturer can store the motor data information in the encoder.
This allows the end user to simply read out the motor data from the encoder
and thus avoid having to enter the motor data, auto tune the motor, or learn
the encoder position.

Follow the procedure carefully as it is possible to overwrite the stored
data with no chance to recover the stored values.
Reading data from the encoder
Start
�����
���
�����
���
�����
�����
�����
����
�����
�����
�����
�����
�����
�����
����
�����
���
����� Enter YES to
confirm. Drive
will read encoder
data, update
the parameter
values and then
�����
reprogram itself
���
using the new
values.
Finished
3