KEB COMBIVERT F5 Instruction Manual page 90

Parameter Description - Encoder Set Up
0
This parameter displays the type of encoder feedback installed in the drive.
It is also used to reset E.ENCC error. Under normal operation this parameter
dispalys the type of encoder feedback card installed in the drive. See the list
below.
Additionally, if an E.ENCC error has occurred, and the problem has been
corrected, the error can be reset by displaying the value of 0.LF.26 and pressing
ENTER. This is the only way to manually reset the E.ENCC error. See 2.LF.26
below for more information on E.ENCC errors.
Display Channel 1 ( X3A)
noInt
No feedback card installed
SSI
5V TTL incremental
rESoL
Resolver
HIPEr
Hiperface
Inc24
15-24V HTL incremental
IncIE
5V TTL incremental
SinCo
Sine Cosine / -SSI
I24PE
15-24V HTL incremental
EndAt
EnDat
PhASE
UVW
This parameter displays the type of encoder connected to the drive. It is only
supported by HIPERFACE, EnDAt or SIN/COS-SSI encoders.
Operator Encoder
Display Type
noEnc No Encoder Detected
SCS 60/70
SCS67
SCn67 SCM 60/70
SIN/COS no abs.
SinCo
SinCo SIN/COS abs.
SSI abs.
SSI
SrS56 SRS 50/60
SRM 50/60
Srn56
EnDat EnDat
EnDat Single Turn
EnDat
EnDat EnDat Multi. Turn
EncUn Encoder Undefined
Channel 2 (X3B)
Synchronous Serial Interface,
absolute multi turn position encoder
5V TTL incremental output
5V TTL incremental output
5V TTL incremental output
5V TTL incremental output
5V TTL incremental output
5V TTL incremental output
5V TTL incremental output
5V TTL incremental output