KEB COMBIVERT F5 Instruction Manual page 115

Terminal
Value Number(s)
64 X2A.12
65
X2A.12,X2A.16
6
X2A.12, X2A.14,
X2A.16
73
X2A.12, X2A.15,
X2A.16
6 X2A.11, X2A.12
7 X2A.11, X2A.12,
X2A.16
101
X2A.11, X2A.12,
X2A,14, X2A.16
105
X2A.11, X2A.12,
X2A,15, X2A.16
128
X2A.13
12 X2A.13, X2A.16
133 X2A.13, X2A.14
X2A.16
137
X2A.13, X2A.15
X2A.16
Diagnostic Parameters
Description
Function
HL Only the High Leveling speed signal at X2A.12
is active. Drive will not run until enable signal on
X2A.16 and direction signal on X2A.14 or X2A.15
are active.
Both the Enable and High Leveling speed
EN,HL
signals are active. A direction signal is required to
allow operation.
Enable, Up and High Leveling speed signals
EN,U,HL
are active. The drive should run in binary speed
mode.
Enable, Down and High Leveling speed signals
EN,D,HL
are active. The drive should run in binary speed
mode.
INS Only the Inspection speed signal is active. Drive
will not run until enable signal on X2A.16 and
direction signal on X2A.14 or X2A.15 are active.
EN,INS Both the Enable and Inspection speed signals
are active. A direction signal is required to allow
operation.
EN,U,INS Enable, Up and Inspection speed signals are
active. The drive should run in binary speed
mode.
Enable, Down and Inspection speed signals
EN,D,INS
are active. The drive should run in binary speed
mode.
Only the High speed signal is active. Drive will
H
not run until enable signal on X2A.16 and direc-
tion signal on X2A.14 or X2A.15 are active.
EN,H Both the Enable and High speed signals are ac-
tive. A direction signal is required to allow opera-
tion.
EN,U,H Enable, Up and High speed signals are active.
The drive should run in binary speed mode.
Enable, Down and High speed signals are ac-
EN,D,H
tive. The drive should run in binary speed mode.
115