Changing Parameter Values; Parameter Structure - KEB COMBIVERT F5 Instruction Manual

Keypad Display
4.4 Changing Parameter Values

4.5 Parameter Structure
LF-Parameter: LF. 2 ... LF.99
These parameters allow the user to program the drive for the given job specifications: motor
data, mechanical data, speeds, profiles, etc.
LP-Parameter LP.1...LP.23
These parameters are used to configure the positioning control.
Ld-Parameter Ld.18...Ld.33
These parameters are used to configure the advanced controllers within the drive.
US-Parameter: US. 1 ... US.10
The US parameters are comprised of configuration parameters: parameter value reset,
selection of operation mode, password entry, etc.
ru-Parameter: ru.0 ... ru.83
The ru parameters are comprised of run parameters for monitoring operation, i.e. actual
values for many internal parameters
do-Parameter: do.42 ... do.83
The do parameters are comprised of parameters for defining the output functions
52
Display Parameter
Identification
START
ENTER FUNC.
F/R SPEED
STOP
All parameter changes are accepted for operation and
saved only after the ENTER key is pressed.
Some parameters, such as the motor data, can not be
changed while the elevator is in operation.
Display Parameter
Value
FUNC.
SPEED
START
ENTER
F/R
STOP
Changing Parameter Values
Increase/Decrease
Parameter Value
FUNC.
SPEED
START
STOP