Drive Configuration - KEB COMBIVERT F5 Instruction Manual

Parameter Description - Basic Set Up
Drive configuration
This parameter is used to put the drive into different modes. The
modes are defined below.
Value range: run
conF Configuration mode. Used in special cases to
StoP Drive stopped. Motor can not run, drive will not
S Lrn System Learn. Auto tunes the drive to the
I Lrn Inertia Learn. Learns the system inertia and
P Lrn Pole Learn. Learns the pole positions of PM
Default setting:
Reserved settings: I Lrn (future function)
i
This parameter is time limited for safety. Once conF is activated
you have 90 seconds to complete the task at hand. After the
timer runs out, the mode will change to StoP. It will be necessary
to change back to conF thus resetting the timer to continue. Once
all set up is complete set this parameter to run.
A short cut exists to toggle between run and Stop. From whatever
parameter is currently being viewed, press and hold the FUNC
and STOP button to change LF.3=Stop. The display will show
"Stop" and return to the previous parameter. It is now possible
to change the parameter value. Press ENT to store the value.
Likewise, to toggle to run mode, press and hold the FUNC and
START key. The display will confirm by displaying run and then
return to the previous parameter.
Run mode. All normal functions.
trouble shoot operation
respond. When using serial com, this mode
allows parameter changes.
motor. Refer to section 5.5.3 and 5.6.3 for
instructions.
activates the FFTC.
motors. Refer to section 5.11.1 and 5.11.2 for
instructions.
Stop
77