Hardware Specifications; Table 61. Ethernet Led Description - Eaton PowerXL DG1 Series VFD Communications Manual

EtherNet/IP On-Board Communications

Hardware Specifications

Ethernet Port LED Indications
Ethernet LED
1. Ethernet Link Status
2. Ethernet Link Speed

Table 61. Ethernet LED Description

LED Meaning
Ethernet Link status Flashes with Ethernet message activity.
Ethernet Link Speed Displays the link speed.
Yellow LED on the Ethernet Jack is ON when link
speed is 100 mbps
Yellow LED on the Ethernet Jack is OFF when link
speed is 10 mbps
30 PowerXL DG1 Series VFD MN040010EN—May 2014 www.eaton.com
Ethernet LED Indications at Power Up
When PowerXL is powered up, an indicator test will be
performed. To allow a visual inspection, the following
sequence will be performed.
1. Turn first indicator Green, all other indicators off.
2. Leave first indicator on Green for approximately
0.25 second.
3. Turn first indicator on Red for approximately
0.25 second.
4. Turn first indicator on Green.
5. Turn second indicator (if present) on Green for
approximately 0.25 second.
6. Turn second indicator (if present) on Red for
approximately 0.25 second.
7 . Turn second indicator (if present) Off.
If other indicators are present, test each indicator in
sequence as prescribed by the second indicator above.
If a Module Status indicator is present, it will be the first
indicator in the sequence, followed by any Network Status
indicators present. After completion of this power up test,
the indicator (s) will turn to a normal operational state.