Figure 22. Cat-5E Cable; Table 64. Powerxl Ethernet/Ip Network Settings - Eaton PowerXL DG1 Series VFD Communications Manual

Connections and Wiring
The EtherNet/IP board supports 10/100 Mb speeds in both
full and half-duplex modes. The boards must be connected to
the Ethernet network with a shielded CAT-5e cable. A
crossover cable (at least CAT-5e cable with STP, shielded
twisted pair) may be needed if you want to connect the
EtherNet/IP board directly to the master appliance.
Use only industrial standard components in the network and
avoid complex structures to minimize the length of response
time and the amount of incorrect dispatches. It is often a
good practice to use a subnet that is different from other
devices not related to the drive control.

Table 64. PowerXL EtherNet/IP Network Settings

Code Parameter
P20.3.1 IP Address Mode
P20.3.2 Active IP Address
P20.3.3 Active Subnet Mask
P20.3.4 Active Default Gateway
P20.3.5 MAC Address
P20.3.6 Static IP Address
P20.3.7 Static Subnet Mask
P20.3.8 Static Default Gateway
P20.3.9 EtherNet/IP Protocol Status
P20.3.10 Connection Limit
Min. Max. Unit
0 2
PowerXL DG1 Series VFD MN040010EN—May 2014 www.eaton.com
EtherNet/IP On-Board Communications

Figure 22. CAT-5e Cable

Default ID
1 1500
1507
1509
1511
1513
192.168.1.254 1501
255.255.255.0 1503
192.168.1.1 1505
0 608
2 609
Note
0 = Static IP
1 = DHCP with AutoIP
0 = Off
1 = Operational
2 = Faulted
33