Eaton PowerXL DG1 Series VFD Communications Manual page 54

EtherNet/IP On-Board Communications
ControlLogix 5000
When using a ControlLogix PLC as a PowerXL EIP master,
you must first configure a compatible EtherNet/IP scanner,
and then map ladder logic variables to the scanner. The
following example is for an RSLogix5000 with a
CompactLogix-L23E-QB1 PLC controller.
Note: Some PLCs do not support polled messaging for
EtherNet/IP . For example, the SLC500 only supports
explicit messaging.
Select windows Start R All Programs. Open RSLogix 5000.
From the Tools drop-down menu, select EDS Hardware
Installation Tool to install the PowerXL Drive EtherNet/IP
EDS file. This file can be downloaded from the Eaton
website.
40 PowerXL DG1 Series VFD MN040010EN—May 2014 www.eaton.com