Option Card Slots
The control board is located inside the control unit of the DG1
Series Drive. There are two slots, labeled A and B, on the
control board. The different option boards can be added to
any slots. For more information see "PowerXL DG1 Option
Board Summary." When the DG1 Series Drive is assembled
at the factory, no option boards are installed in slots A and B.
If an incorrect board is plugged into either slot, the board will
not work, but there is no danger to personal or for equipment
damage.
Figure 4. Drive Control Board Layout Showing Option Card Slots
Fan Power Wire
STO
AI Mode Selection
Control I/O
Terminals
Removable
EMC Screw
Line Ground
Clamp Location
Line Ground
Clamp Location
Grounding
Strap Location
Line Side
Connect DSP Part
to Power Board
Keypad
Connect MCU Part
to Power Board
Battery (Standard)
RJ45 EtherNet/IP, BACnet,
IP Modbus TCP
Optional Card A
Optional Card B
ON
1
RS-485 Termination
Resistor
Removable
MOV Screw
Motor Ground
Clamp Location
Grounding
Strap Location
Motor
PowerXL DG1 Series VFD MN040010EN—May 2014 www.eaton.com
Figure 3. DG1 Series Control Board Location
Option Card Slots
3