Eaton PowerXL DG1 VFD Series Quick Start Manual
With power xpert incontrol software
Hide thumbs
Also See for PowerXL DG1 VFD Series:
- Communications manual (152 pages) ,
- Quick start manual (40 pages) ,
- Instruction leaflet (25 pages)
Advertisement
PowerXL DG1 Series VFD
in
Power Xpert
Step 1 – Installation
Download the Power Xpert inControl Software with the One Installer found on the
www.eaton.com/dg1
Step 2 – Connecting
Keypad Port: Using the PowerXL DG1 programming cable (Part Number DXG-
CBL-PCCABLE) connect from your computer USB port to the keypad port.
Ethernet Port: Using any standard CAT5 Ethernet cable connect from your
computer to the RJ45 Ethernet Port. Note: Your drive IP address will have to be
set up in the drive keypad parameters (Group P20.3) to match the IP address
structure in your computer before connecting.
Step 3 – Configuring Connection
Open Power Xpert inControl and double click on either the Modbus Serial (Keypad Port)
or Modbus TCP (Ethernet Port) on the right side in the Device Catalog (red). Once com-
plete, the device DTM should then show up in the Network View (blue).
If the Modbus Serial (Keypad Port) is selected the Communication Settings window will
come up which should be set to the following values.
Configuration Parameter
Port
Parity*
Data Bits*
Baud Rate*
Stop Bits*
Transmission Mode*
Control Quick Start Guide
software tab.
Setting
Need to check in windows device properties for port
USB to RS485 adapter was installed at.
Even
8
38400
1
RTU
Effective July 2014
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Eaton PowerXL DG1 VFD Series
Summary of Contents for Eaton PowerXL DG1 VFD Series
- Page 1 Control Quick Start Guide Step 1 – Installation Download the Power Xpert inControl Software with the One Installer found on the www.eaton.com/dg1 software tab. Step 2 – Connecting Keypad Port: Using the PowerXL DG1 programming cable (Part Number DXG- CBL-PCCABLE) connect from your computer USB port to the keypad port.
- Page 2 With the PowerXL DG1 drive selected, click the Go Online button. Then double click on the drive to load device parameters, these will be shown in the main window (green). The PowerXL DG1 is now ready to be configured by the Power Xpert inControl software. www.eaton.com EATON CORPORATION...
- Page 3 Effective July 2014 Additional Help In the US or Canada: please contact the Technical Resource Center at 1-877-ETN-CARE or 1-877-326-2273 option 2, option 6. All other supporting documentation is located on the Eaton web site at www.eaton.com/Drives Eaton 1000 Eaton Boulevard Cleveland, OH 44122 USA Eaton.com...
Need help?
Do you have a question about the PowerXL DG1 VFD Series and is the answer not in the manual?
Questions and answers
WE HAVE YOUR VFD DRIVE IN A FEED MILL , THEIR IS SOME DUST , HOW DO YOU CLEAN UP THE FANS TO GET BETTER AIRFLOW