Table 83. Vendor Specific Objects - Eaton PowerXL DG1 Series VFD Communications Manual

EtherNet/IP On-Board Communications
Vendor Parameters Object, Class 0xA0
Vendor parameter object is used in order to get access to drive parameters. Because drive
parameters are identified by the 16-bit length ID number, it is impossible to use only
attribute ID, which is 8-bit in length. To overcome this issue, we are using the following
method to calculate requested drive parameter ID.
Drive parameter ID = instance ID (higher byte) + attribute ID (lower byte).

Table 83. Vendor Specific Objects

ID Description
Class Attributes
01h Revision
02h Max Instance
03h Number of Instances
Class Services
0Eh Get_Attribute_Single
Instance Attributes
LOWER BYTE OF THE PARAMETER ID
Instance Services
0Eh Get_Attribute_Single
10h Set_Attribute_Single
Note: All the drive parameters given in the application
manual are accessible using the vendor parameter
object.
62 PowerXL DG1 Series VFD MN040010EN—May 2014 www.eaton.com
Data Type Access Rule
UINT Get
UINT Get
UINT Get
Remarks/Default
1
0X05
0X05