Emc Directive; Control Cable Grounding; Figure 5. Control Cable Grounding; Table 3. Control Wiring Requirements - Eaton PowerXL DG1 Series VFD Communications Manual

EMC Directive

For the electrical equipment installed in the EMC, directive
states that the equipment must not disturb the environment
and must be immune to other electromagnetic disturbances
in the environment. Table 3 indicates the requirements for
the control wiring to meet this directive.

Table 3. Control Wiring Requirements

Item Directive
Product IEC 61800-2
Safety UL 508C, IEC / EN 61800-5-1
EMC (at default Immunity: EN / IEC 61800-3, 2nd environment
settings)
Radiated emissions: EN / IEC 61800-3 (Transient Testing
included), 1st environment
Conducted emissions: EN / IEC 61800-3
Category C1: is possible with external filter connected to
drive. Please consult factory
Category C2: with internal filter maximum of 10m motor
cable length
Category C3: with internal filter maximum of 50m motor
cable length
Table 4. PowerXL Series—DG1 General Purpose Drive Option Boards
Basic Naming
DX = PowerXL Drive

Control Cable Grounding

It is recommended that the shielded cables be grounded as
shown in Figure 5. Strip the cable insulation required
allowing attachment to the frame with the grounding clamp.

Figure 5. Control Cable Grounding

DX G – NET – PROFB
Series
G = General purpose NET = Communication card
EXT = I/O card
ACC = Accessory
SPR = Spare part
KEY = Keypad
CBL = Cable
PowerXL DG1 Series VFD MN040010EN—May 2014 www.eaton.com
Type Function
PROFIBUS = PROFIBUS
DEVICENET = DeviceNet
LONWORKS = LonWorks
CANOPEN = CANopen
SWD = SmartWire
See Volume 6, CA08100007E,
Tab 2, PowerXL DG1 Accessories
for full offering
Option Card Slots
5