d.
Setting Modbus TCP Unit ID
Figure 18. Modbus TCP Unit ID
3.
Make note of the changed IP Address.
4.
Power off the drive control and wait three minutes for
the internal voltages to dissipate.
5.
Using PowerXL drive keypad, read "Active IP Address"
(Keypad menu. P20.3.2), "Active Subnet Mask" (Keypad
menu. P20.3.3), "Active Default Gateway" (Keypad
menu. P20.3.4) parameters to ensure that IP address
has been set to desired IP address.
Modbus TCP On-Board Communications
PowerXL DG1 Series VFD MN040010EN—May 2014 www.eaton.com
23