Quick Settings; Calibration Settings - Agilent Technologies N9913A User Manual

How to activate a trace in order to change a setting
 Use the ▲|▼ arrows OR
 Press Trace 6 then select
How to maximize the viewing of the active trace
 Press System 7
 Then
 Press any key to return to the standard display.

Quick Settings

Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus.
How to view and change Quick Settings
 Press Meas Setup 4.
 Then Settings.
 Press
 To change a setting:
 Press
When finished changing ALL settings, press

Calibration Settings

NA Mode has a page specifically for making settings that pertain to Port
Extensions, including Velocity Factor and Media Type.
Learn more about Port Extensions on page 52.
Learn more about Media Type in Waveguide Calibrations on page 76.
44
that are shown can be activated.
Full Screen.
and
Next Page Previous Page
NOT available, then all available settings fit on one page.
Use the ▲|▼ arrows to highlight a setting.
o
Then press Edit. The current setting changes to
o
Some settings require you to press a softkey to change the value. Otherwise,
o
use the numeric keypad, ▲|▼ arrows, or rotary knob to change the value.
When finished changing a value, press
o
to relocate the Settings table to a position relative to the
Dock Window
trace window. The Dock Window setting persists through a Preset. Choose
from the following:
Full (Default setting) Only the Settings table is shown on the screen. The
o
trace window is temporarily not shown.
Left The Settings table is shown to the left of the trace window.
o
Bottom The Settings table is shown below the trace window.
o
Trace 1, Trace 2, Trace
to view all settings. If these softkeys are
yellow.
Done Edit.
Done to save your settings.
3, or Trace 4, Only traces
FieldFox User's Guide