Quick Settings - Agilent Technologies FieldFox N9912A User Manual

 By default, a marker is created on ALL traces as show in the above image.
How to select a multi-trace configuration
 Press Trace 6
 Then
 Then choose from the following:
How to activate a trace in order to change a setting
 Use the ▲|▼ arrows OR
 Press Trace 6 then select
How to maximize the viewing of the active trace
 Press System 7
 Then
 Press any key to return to the standard display.

Quick Settings

Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus.
How to view and change Quick Settings
 Press Meas Setup 4.
 Then Settings.
 Press
 To change a setting:
NA (Network Analyzer) Mode
However, they can be created individually by disabling Coupled Markers.
Learn more on page 124.
Num Traces
The default measurements depend on the options that are installed.
x1 1 trace standard configuration
2 traces overlayed on a single graticule
x2
2 traces on separate horizontal graticules
x2H
3 traces on separate horizontal graticules
x3H
4 traces on separate graticules
x4
that are shown can be activated.
Full Screen.
and
Next Page Previous Page
NOT available, then all available settings fit on one page.
Use the ▲|▼ arrows to highlight a setting.
o
Then press Edit. The current setting changes to
o
Some settings require you to press a softkey to change the value. Otherwise,
o
use the numeric keypad, ▲|▼ arrows, or rotary knob to change the value.
Trace 1, Trace 2, Trace
to view all settings. If these softkeys are
yellow
3, or 4, Only traces
Trace
.
39