Cat (Cable And Antenna Test) Mode - Agilent Technologies N9913A User Manual

CAT (Cable and Antenna Test) Mode

CAT Mode is typically used to test an entire transmission system, from the
transmitter to the antenna. This process is sometimes referred to as Line
Sweeping.
CAT Mode is similar to NA (Network Analyzer) Mode. Learn more in the
Supplemental Online Help:
CAT Mode Distance to Fault measurements are discussed on page 30.
In this Chapter
Measurement Selection ......................................... 21
Quick Settings ........................................................ 22
Frequency Range ................................................... 22
Scale Settings ......................................................... 23
Averaging ............................................................... 24
Single/Continuous ................................................. 24
Resolution ............................................................... 25
Sweep Time ............................................................. 25
Output Power ......................................................... 25
Interference Rejection .......................................... 26
Coupled Frequency ............................................... 27
Procedures
Return Loss Measurement ................................... 27
1-Port Cable Loss Measurement .......................... 28
2-Port Insertion Loss Measurement ................... 29
Distance to Fault Measurements ......................... 30
See Also
All about Calibration ............................................. 55
Set Markers ........................................................... 174
Use Limit Lines .................................................... 184
Use Trace Math .................................................... 187
Making 75Ω (ohm) Measurements at the FieldFox Supplemental Online Help:
http://na.tm.agilent.com/fieldfox/help/FieldFox.htm
20
http://na.tm.agilent.com/fieldfox/help/FieldFox.htm
FieldFox User's Guide