Agilent Technologies N9913A User Manual page 145

How to set Source Control and Power Level
 Press Freq/Dist
 Then
NOTE When Option 208 (FOPS) is enabled, to access Source Control, press Sweep 3
Then
 Then
Optionally set the power level.
 Press
 Then enter a value using the numeric keypad, the ▲|▼ arrows, or the rotary
 Press
Scale
The scale of the Power Meter display can be set manually or automatically. The
major and minor ticks are set automatically and can NOT be changed. Although
the scale settings are limited, you can view measurements beyond these settings
by performing Autoscale.
How to Scale the Power Meter display
Manually:
 Press Scale / Amptd .
 Then choose from the following:
Autoscale:
Using Autoscale, the current reading is used for the center of the scale, and Min
and Max values are set accordingly.
 Press Scale / Amptd .
 Then
 Then Autoscale.
Power Meter (USB) Mode
Advanced
Learn more about FOPS beginning on page 149.
Power Setup
Source Enable
ON Turn ON the internal source
o
OFF Turn OFF the internal source
o
Src Nom Power
arbitrary value at the displayed CW frequency.
knob.
Enter
Scale Min Sets the low power level of the power meter display. Type a
o
number and select the units or press Enter. This value is limited to –100
dBm.
Sets the high power level of the power meter display. Type a
Scale Max
o
number and select the units or press Enter. This value is limited to 100
dBm.
More .
(-15 dBm default setting) Set output power to an
145