Install The Lithium-Ion Battery - Agilent Technologies N9913A User Manual

Install the Lithium-Ion Battery

Step
1. Open the battery door.
2. Insert the battery.
3. Close the battery door.
Battery Usage
When you receive your FieldFox, the lithium-ion battery is not installed, and it is
partially charged to approximately 40% to preserve battery life. A lithium-ion
battery has no memory effect, so it can be used partially charged, as shipped.
A fully charged battery will power your FieldFox for about four hours, so if you
plan to use it for this long, you should fully charge the battery.
NOTE The FieldFox will shut down to prevent the battery from discharging to a level
that is damaging. If this occurs, charge the battery either internally or externally.
Learn more about the lithium-ion battery on page 216.
Battery charge status is viewable:

 On the Battery screen. To access the screen, select System,
 On the battery. Open the FieldFox battery compartment door to view the
To conserve battery power:
 Use Run/Hold to single-trigger a measurement when needed.
 Press System then
 Briefly press the power button to switch to Stand By mode when the FieldFox
Preparing for Initial Use of Your New FieldFox
Notes
Push the button on the battery compartment door while sliding the door outward.
The terminals end of the battery is inserted into the compartment.
Slide the battery compartment door upwards until it latches.
In the upper-right corner of the screen.
Diagnostics, and Battery.
battery LCD.
the display.
Display
knob, or numeric keypad to adjust the brightness to dim the FieldFox display
as much as possible.
is not being used. Press again to restore power. All current settings are
preserved.
then Brightness. Use the ▲|▼ arrows, the rotary
Service
is shown on
Hold
11