Agilent Technologies N9913A User Manual page 90

 Learn how to set Y-Axis Units on page 86.
 Use a Band Power marker to measure total power over a range of frequencies.
How to select correction for Field Strength measurements
The Antenna and Cable correction data survives a Mode Preset and Preset.
All Correction ON/OFF states survive a Mode Preset, but NOT a Preset.
 Press Scale/Amptd .
 Then
 Then
 Then choose from the following:
Using the Antenna/Cable Editor
The Antenna Editor and the Cable Editor menus are very similar. Both tables
include header information, and a Frequency/Value table.
NOTE The FieldFox limits Antenna and Cable correction to a maximum of 90 values.
FieldFox Antenna Editor
How to use the Antenna/Cable Editor
 Press
 Then
90
Learn how on page 184.
More
Corrections
Apply Corrections ON OFF
o
Antenna ON OFF Turn ON and OFF Antenna correction.
o
Edit/Save/Recall Antennas
o
below.
Turn ON and OFF Cable correction.
Cable ON OFF
o
Edit/Save/Recall Cables
o
View Corrections ON OFF
o
corrections.
then to clear all data from the existing Antenna or Cable table
New Yes
and reset header information to default settings.
or
Edit Antenna
Turn ON and OFF correction for all settings
Recall or edit an Antenna Correction table. See
Recall or edit a Cable Correction table. See below.
Turn ON and OFF
to open the Antenna / Cable Editor.
Edit Cable
Red Trace - Antenna/Cable
FieldFox User's Guide