Reflection Mode (Sa Models) - Agilent Technologies N9913A User Manual

Reflection Mode (SA Models)

This feature may require an option. Please view the FieldFox Configuration
Guide at:
Reflection Mode provides 1-port scalar reflection measurements in selected
FieldFox SA-Only models. The FieldFox source is routed internally to Port 1 and
used to stimulate a Device Under Test (DUT). The energy that is reflected off the
DUT is measured and displayed on the screen.
SA mode reflection measurements are very similar to CAT mode reflection
measurements. Although SA mode reflection measurements are CalReady, other
CAT mode calibration types are NOT offered. Learn more about CalReady on
page 65.
In this Chapter
Measurement Selection ....................................... 137
Normalize .............................................................. 137
The following settings are available exactly as they function in CAT mode:
Frequency Range ................................................... 22
Scale Settings ......................................................... 23
Averaging ............................................................... 24
Single/Continuous ................................................. 24
Resolution ............................................................... 25
Sweep Time ............................................................. 25
Output Power ......................................................... 25
Interference Rejection .......................................... 25
Markers .................................................................. 174
Limit Lines ............................................................ 184
136
http://cp.literature.agilent.com/litweb/pdf/5990-9836EN.pdf
FieldFox User's Guide