Agilent Technologies N9913A User Manual page 102

 In Zero span, you can use Trigger Position as an easy way to set Trigger Delay
 Press Sweep 3
 Then
 Then
 Enter a value using the numeric keypad, the ▲|▼ arrows, or the rotary knob.
 Then select a multiplier key or press Enter. Learn about multiplier
Trigger Level
Used with Video and RF Burst triggering, a sweep is initiated when an incoming
signal crosses this level. The units depend on the Units setting. Learn more on
page 86.
Video Trigger Level is a zero span signal level comparison. Therefore, the sweep
will trigger close to the displayed level in zero span measurements. In non-zero
span measurements, processing can cause broadband signal energy to display at
lower power levels than the originating time domain signal. Therefore, you may
need to set the trigger level higher than the displayed level.
RF Burst Trigger Level uses an alignment process which is performed in the
background to set the detected signal level accuracy. Learn more about the
alignment on page 108.
 Press Sweep 3
 Then
 Then
 Enter a value using the numeric keypad, the ▲|▼ arrows, or the rotary knob.
 Then select a multiplier key or press Enter. Learn about multiplier
Auto Trigger Time
While waiting for a valid trigger signal,
the FieldFox screen.
If a valid trigger signal is not received before the specified Auto Trig Time, a
sweep will occur automatically.
Enter 0 to set Auto Trigger OFF. When Auto Trigger is OFF, the FieldFox does
NOT sweep unless a valid trigger signal is received.
 Press Sweep 3
 Then
 Then
 Enter an Auto Trig Time using the numeric keypad.
 Then select a multiplier key. Learn about multiplier abbreviations on page 19.
102
by positioning the trigger event on the FieldFox screen.
Trigger Settings
Trig Delay
abbreviations on page 19.
Trigger Settings
Trig Level
abbreviations on page 19.
Trigger Settings
AutoTrig Time [current setting]
Wait is annotated in the top left corner of
FieldFox User's Guide