Preset - Agilent Technologies N9913A User Manual

Use Hold to conserve battery power or to allow you to save or analyze the results
of a specific measurement sweep.
The current sweep mode is shown on the screen as:

 Hold

How to perform a single sweep while in Hold
 Press Sweep 3.
 Then choose one of the following:

Preset

The Preset key restores the FieldFox measurement settings to a known condition.
You can preset the entire instrument, or just the current Mode (CAT, SA, and so
forth).
When Preset, the FieldFox CalReady calibration is recalled for use in CAT and
NA Modes. Learn more on page 65.
In addition to all Preference settings, the following settings always survive
Preset and Mode Preset:
 External Reference state (page 209)
 SA Units (page 86)
 SA Correction states (page 89)
 VVM Display Resolution (page 168)
 Marker Peak Excursion and Threshold (page 182)
How to Preset the FieldFox
 Press Preset.
 Then choose one of the following:
System Settings
Continuous
Hold
-->
is displayed while a single sweep occurs.
Automatically sets Continuous OFF (Hold) and causes FieldFox to
Single
o
make ONE measurement sweep, then hold for the next Single key press.
SA Mode ONLY – With
o
also causes a single sweep.
Continuous ON OFF
o
when battery power is not critical.
Returns ALL Modes to the factory default settings.
Preset
o
Returns only the current Mode to the factory default settings.
Mode Preset
o
The current settings for all other Modes remain.
each successive Run/Hold press
Continuous OFF
Makes continuous sweeps. This is the typical setting
199