Quick Settings; Frequency Range - Agilent Technologies FieldFox N9923A User Manual

Quick Settings

Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus.
How to view and change Quick Settings
 Press Meas Setup 4.
 Then Settings.
 Press
 To change a setting:
The Quick Settings menu. The resolution is being edited.

Frequency Range

Set the range of frequencies over which you would like to make CAT Mode
measurements.
When the frequency range is changed after a calibration is performed, the cal
becomes interpolated. Learn more on page 51.
How to set Frequency Range
 Press Freq/Dist .
 Then choose from the following:
CAT (Cable and Antenna Test) Mode - Option 305
2-Port Insertion Loss
o
displays the loss through a cable or other device in dB. Both ends of the
cable must be connected to the FieldFox. NO phase information is included
in this measurement. Learn more on page 41.
and
Next Page Previous Page
NOT available, then all available settings fit on one page.
Use the ▲|▼ arrows to highlight a setting.
o
Then press Edit. The current setting changes to
o
Some settings require you to press a softkey to change the value. Otherwise,
o
use the numeric keypad, ▲|▼ arrows, or rotary knob to change the value.
When finished changing a value, press
o
When finished changing settings, press Done.
o
2-port transmission measurement that accurately
to view all settings. If these softkeys are
Done Edit.
yellow.
35