Recall Files; Set File Type And Device - Agilent Technologies N9913A User Manual

Recall Files

The FieldFox can recall State files, Trace + State files, and image files.
State Files
ALL FieldFox instrument settings for ALL Modes are saved and recalled in a
*.sta file. If error correction is ON in CAT or NA Mode, then calibration data is
also saved and recalled.
If error correction is OFF (CalRdy is active), calibration data is NOT saved in the
*.sta file. When a Trace + State file is recalled on a FieldFox other than the one it
was saved on, differences in the CalRdy calibration data may result in
differences between the displayed traces.
Image Files
The FieldFox can open and display *.png, *.jpg, and *.jpeg files.
How to Recall a File
NOTE Before recalling a file, first Select the Device and Location from which the file
will be recalled. See the following section for more information.
 Press Save/Recall 9
 Then
 Navigate to the file to be recalled using the Up/Down arrow keys.
 Then
Set File Type and Select Device
The following File TYPE and DEVICE settings are used to determine the type of
file to save, and the location to be used for all file operations.
These two settings remain through an instrument preset, but are reset to the
default values when the FieldFox power is shutdown.
Select Device (location of File Save/Recall)
 Press Save/Recall 9
 Then
NOTE Insert only ONE USB Flash Drive in the FieldFox when saving or copying files.
How to set File Type
State files are the only file type that can be recalled by the FieldFox.
 Press Save/Recall 9
192
Recall
or Enter
Recall File
to set the LOCATION where the file is to be saved or
Select Device
recalled. Choose from the following:
Saves/Recalls files to/from the FieldFox internal memory. To
Internal
o
specify a folder, first select Manage Folders (learn how on page 195). The
Data Link software will read data ONLY from the \UserData folder.
Saves/Recalls files to/from the SD card (not included), inserted in
SD Card
o
the card slot. See FieldFox Tour on page 14. Only the root folder is available.
Saves/Recalls files to or from a USB Flash drive (not included) that is
USB
o
inserted in one of the USB connectors. Only the root folder is available.
FieldFox User's Guide