Built-In Power Meter Mode - Option 310 - Agilent Technologies N9913A User Manual

Built-in Power Meter Mode - Option 310

Built-in Power Meter (also known as Channel Power Meter) uses the SA input
connector to make quick and simple power measurements over a selectable
frequency band. A power sensor is NOT required.
In this Chapter
Set Frequency ....................................................... 140
Radio Standard .................................................... 140
Attenuation ........................................................... 141
See Also
The following Built-in Power Meter settings are identical to the standard Power
Meter settings:
Set Scale ................................................................ 144
Set Relative and Offset Power ........................... 146
Set Display Units ................................................. 146
Set Averaging........................................................ 147
Single/Continuous ............................................... 147
Set Limits .............................................................. 147
The following Built-in Power Meter settings are identical to SA Mode settings:
Radio Standard ...................................................... 84
InstAlign Amplitude Alignment ........................ 107
Built-in Power Meter Settings
Select Built-in Power Meter Mode before making any setting in this section.
Built-in Power Meter Mode - Option 310 139