Quick Settings; Format - Agilent Technologies FieldFox N9913A User Manual

How to activate a trace in order to change a setting
 Use the ▲|▼ arrows OR
 Press Trace 6 then select
How to maximize the viewing of the active trace
 Press System 7
 Then
 Press any key to return to the standard display.

Quick Settings

Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus.
How to view and change Quick Settings
 Press Meas Setup 4.
 Then Settings.
 Press
 To change a setting:
 Press
When finished changing ALL settings, press

Format

Select the display format in which to present measurement results. This setting
can be changed at any time without affecting calibration accuracy.
NOTE Learn more about Display Formats in the FieldFox Supplemental Online Help:
http://na.tm.agilent.com/fieldfox/help/FieldFox.htm
42
that are shown can be activated.
Full Screen.
Next Page Previous Page
and
NOT available, then all available settings fit on one page.
Use the ▲|▼ arrows to highlight a setting.
o
Then press Edit. The current setting changes to
o
Some settings require you to press a softkey to change the value. Otherwise,
o
use the numeric keypad, ▲|▼ arrows, or rotary knob to change the value.
When finished changing a value, press
o
Dock Window
to relocate the Settings table to a position relative to the
trace window. The Dock Window setting persists through a Preset. Choose
from the following:
Full (Default setting) Only the Settings table is shown on the screen. The
o
trace window is temporarily not shown.
Left The Settings table is shown to the left of the trace window.
o
Bottom The Settings table is shown below the trace window.
o
Trace 1, Trace 2, Trace
to view all settings. If these softkeys are
yellow.
Done Edit.
Done
to save your settings.
3, or Trace 4, Only traces
FieldFox User's Guide