FieldFox Data Flow and Record Playback data points
Data can be recorded at the Raw Meas block where data is acquired after
Data can be recorded from Traces 1,2,3, or 4 which includes the trace state
Recording from a Clear/Write trace yields exactly the same data as recording
Data is ALWAYS played back at the same location in the data flow: just after
See an example using Record Playback with Max Hold traces on page 134.
Playback Configuration
By default, trace sweeps are played back as fast as the trace can be drawn on the
screen. The following setting allows you to slow playback. In addition, you can
manually scroll through individual traces using Playback Trace, or scroll through
State and User Tags using Playback State/Tag. Learn more in How to Playback a
Session on page 130.
To slow playback of a session
Record a new session or Open an existing session.
Press
Then
Enter a value in seconds between 0 (no delay) and 100 using the numeric
Press
Manage Sessions
Press Trace 6
Then
The following selections are available ONLY when a session is NOT open.
Then
Interference Analyzer (SA Mode) - Option 236
ResBW, VideoBW, and Detector processing, but before any trace state
processing.
(Max Hold, Min Hold, and so forth.
from the Raw Meas block.
the Raw Meas block, through all currently active Traces, and onto the display.
Playback Configuration
Playback Interval
keypad, ▲|▼ arrows, or the rotary knob. After using the keypad, select a
multiplier key. Learn about multiplier abbreviations on page 19.
Enter
Record Playback Setup
to select the media which stores the sessions to be
Storage Device
managed. This is a different setting from the Save/Recall Storage Device
setting.
133