Vlan Configuration Task List - Planet Networking & Communication WGSW-50040 Configuration Manual

The switch implements VLAN and GVRP (GARP VLAN Registration Protocol) which are defined by 802.1Q.
The chapter will explain the use and the configuration of VLAN and GVRP in detail.

10.1.2 VLAN Configuration Task List

1. Create or delete VLAN
2. Set or delete VLAN name
3. Assign Switch ports for VLAN
4. Set the switch port type
5. Set Trunk port
6. Set Access port
7. Enable/Disable VLAN ingress rules on ports
8. Configure Private VLAN
9. Set Private VLAN association
1. Create or delete VLAN
Global Mode
vlan WORD
no vlan WORD
2. Set or delete VLAN name
Global Mode
name <vlan-name>
no name
3. Assigning Switch ports for VLAN
VLAN Mode
switchport interface <interface-list>
no switchport interface <interface-list>
4. Set the Switch Port Type
Port Mode
switchport mode {trunk | access}
Command
Command
Command
Command
Explanation
Create/delete VLAN or enter VLAN Mode
Explanation
Set or delete VLAN name.
Explanation
Assign Switch ports to VLAN.
Explanation
Set the current port as Trunk or Access
port.
10-2