Planet Networking & Communication WGSW-50040 Configuration Manual page 27

3) In the "Connecting using" drop-list, select the RS-232 serial port used by the PC, e.g. COM1, and click
"OK".
4) COM1 property appears, select "9600" for "Baud rate", "8" for "Data bits", "none" for "Parity checksum", "1"
for stop bit and "none" for traffic control; or, you can also click "Restore default" and click "OK".
Figure 3-4 Opening HyperTerminal
Figure 3-5 Opening HyperTerminal
3-10