Product Features - Planet Networking & Communication WGSW-50040 Configuration Manual

1.3 Product Features


Physical Port
 50-Port 10/100/1000Base-T Gigabit Ethernet RJ-45
 4 mini-GBIC/SFP slots, shared with Port-45 to Port-48
 RJ-45 to DB9 console interface for Switch basic management and setup

IP Stacking
 Connects with stack member via both Gigabit TP/SFP interface
 Single IP address management, supports up to 24 units stacking together
 Stacking architecture supports Chain and Ring mode

Layer 2 Features
 Complies with the IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z Gigabit Ethernet standard
 Supports Auto-negotiation and Half-Duplex / Full-Duplex modes for all 10Base-T/100Base-TX and
1000Base-T ports.
 Supports 1000Base-SX/LX for all SFP interfaces
 Auto-MDI/MDI-X detection on each RJ-45 port
 Prevents packet loss Flow Control:
- IEEE 802.3x PAUSE Frame flow control for Full-Duplex mode
- Back-Pressure Flow Control in Half-Duplex mode
 High performance Store and Forward architecture, broadcast storm control, port loopback detect
 8CKC MAC address table, automatic source address learning and ageing
 Support VLAN
- IEEE 802.1Q Tag-based VLAN
- GVRP for dynamic VLAN Management
- Up to 4K VLANs groups, out of 4041 VLAN IDs
- Provider Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
- Private VLAN Edge (PVE) supported
- GVRP protocol for Management VLAN
 Support Link Aggregation
- Maximum 8 trunk groups, up to 8 ports per trunk group
- IEEE 802.3ad LACP (Link Aggregation Control Protocol)
- Cisco ether-channel (Static Trunk)
 Spanning Tree Protocol
- STP, IEEE 802.1D (Classic Spanning Tree Protocol)
- RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)
- MSTP, IEEE 802.1s (Multiple Spanning Tree Protocol, spanning tree by VLAN)
- Supports BPDU & port guard
 Port Mirroring to monitor the incoming or outgoing traffic on a particular port (many to many)
 Provides Port Mirror (many-to-1)
1-3