Planet Networking & Communication WGSW-50040 Configuration Manual page 233

4. Configure the parameter of the RADIUS service
Global Mode
radius-server dead-time <minutes>
no radius-server dead-time
radius-server retransmit <retries>
no radius-server retransmit
radius-server timeout <seconds>
no radius-server timeout
radius-server accounting-interim-update
timeout <seconds>
no radius-server
accounting-interim-update timeout
5. Configure the IP address of the RADIUS NAS
Global Mode
radius nas-ipv4 <ip-address>
no radius nas-ipv4
radius nas-ipv6 <ipv6-address>
no radius nas-ipv6
Command
Command
Explanation
To configure the interval that the RADIUS
becomes available after it is down. The no
form of this command will restore the
default configuration.
To configure retry times for the RADIUS
packets. The no form of this command
restores the default configuration.
To configure the timeout value for the
RADIUS server. The no form of this
command will
configuration.
To configure the update interval for
accounting. The no form of this command
will restore the default configuration.
Explanation
To configure the source IP address for the
RADIUS packets for the switch.
To configure the source IPv6 address for
the RADIUS packets for the switch.
30-4
restore the default